Speed Queen SF7000WE Installation Manual download pdf (Page 9)

Installation

Before You Start

Tools

For most installations, the basic tools you will need are:

SWD1021N_SVG

1. Wrench

2. 1/4 inch Driver

3. Screwdriver

4. Level

5. Wood Block

6. Pliers

7. 5/16 Inch Socket Wrench

8. Gloves

9. Teflon Tape (Gas Models)

10. Duct Tape

11. Safety Glasses

Figure 1

NOTE: If the unit is delivered on a cold day (below

freezing), or is stored in an unheated room or area dur-

ing the cold months, do not attempt to operate it until

the unit has had a chance to warm up.

NOTE: Some moisture in the wash drum is normal. Wa-

ter is used during testing at the manufacturer.

NOTE: This appliance is suitable for use in countries

having a warm, damp climate.

WARNING

Any disassembly requiring the use of tools must be

performed by a suitably qualified service person.

W299

Parts Included

An accessories bag has been shipped inside your unit. It includes:

• Installation Instructions

• Two User's Guides (one for washer and one for dryer)

• Warranty Bond

• Three screws (electric dryers only)

• Two fill hoses with washers and filter screens

• Four rubber feet

• Beaded strap

Removing Dryer

Use the following steps if the installation requires removal of the

dryer. Two people are required to perform this task.

1. Remove dryer front access panel.

2. Remove two screws holding control panel to control cabinet.

3. Remove two 7/16 inch screws and washers attaching dryer to

washer.

4. Tip dryer back and disconnect dryer control wire harness

from main dryer wire harness.

5. Slide dryer forward until rear leveling legs slide into notches

in the control cabinet.

6. Lift dryer and place it on a level surface.

Reassembling Dryer

1. Lift dryer and place it on top of washer so dryer leveling legs

sit in notches in control cabinet.

2. Slide dryer backward until mounting holes in base line up

with holes in front of security cabinet.

3. Reconnect dryer wire harness. If needed, refer to unit’s wiring

diagram.

4. Tip dryer and replace two 7/16 inch screws and washers hold-

ing dryer to washer.

5. Reattach the control panel to the control cabinet using two

screws.

6. Replace dryer’s front access panel.

Installation

DO NOT COPY or TRANSMIT

9 Part No. 804671ENR4

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

Comments to this Manuals

No comments

Speed Queen SF7000WE Installation Manual Page 9

Comments to this Manuals

Related products and manuals for Electric laundry dryers Speed Queen SF7000WE