Speed Queen SF7000WE User Manual download pdf (Page 30)

Washer Symptom Possible/Cause Solution

Er, nF on digital display

• The washer has not filled to the proper water level.

• No or very little change in water level has been sensed

within 5 minutes of the current fill.

• Make sure hot and cold water faucets are turned on.

• Make sure that the fill hoses are not kinked or twisted.

• Clean the screens in the water mixing valve and the filter

screens located at the faucet end of the fill hoses.

• Unplug the machine for 15 seconds to clear this code.

Er, OF on digital display

• This code indicates the washer has filled to the overflow

level.

• The machine will begin to attempt to pump water out if the

door is closed and locked.

• Foreign object trap in pump may be clogged. Clean the

trap. Refer to Maintenance section.

• If the code does not clear, unplug the machine and call for

service.

Er, PS on digital display

• The control has detected trouble sensing the water fill lev-

el.

• Unplug the machine and call for service.

Er, dU on digital display

• The control senses that the door will not unlock.

• Unplug the machine for three minutes to unlock the door.

• If the code appears again, call for service.

Er, dl on digital display

• This code indicates that the door has not locked.

• Make sure the door is closed all the way and try to start

the cycle.

• Open the door or unplug the machine to clear the code.

• If this code continues, call for service.

Er, ub on digital display

Left Decimal Point blinking on display one second on/one

second off

• This code indicates that the washer did not reach the maxi-

mum intended speed in the final spin.

• This could be due to an unbalanced load, excessive suds

in the load, or too much water left in the tub due to slow

draining.

• Be sure to use proper load sizes that are evenly distributed

in the wash basket.

• Be sure to use high efficiency (HE) detergent.

• Open the door or press the Power/Cancel keypad to clear

this code.

PF on digital display

• This code will be displayed if the control was in Delay Start

Mode when a power failure occurred.

• The delayed start will be canceled.

• Press the Power/Cancel Pad to clear the code.

Table continues...

Troubleshooting

DO NOT COPY or TRANSMIT

30 Part No. 806970EN

1 2 ... 25 26 27 28 29 30 31 32

Comments to this Manuals

No comments

Speed Queen SF7000WE User Manual Page 30

Comments to this Manuals

Related products and manuals for Washing machines Speed Queen SF7000WE