Speed Queen DR5000WE Installation Manual download pdf (Page 21)

The three-prong grounding plug on the power cord should be

plugged directly into a polarized three-slot effectively grounded

receptacle rated 120 Volts AC (alternating current) 15 Amps. Re-

fer to Figure 26 to determine correct polarity of the wall recepta-

cle.

Grounding Information

This dryer must be grounded. In the event of malfunction or

breakdown, grounding will reduce the risk of electric shock by

providing a path of least resistance for electric current. The dryer

is equipped with a cord having an equipment-grounding conduc-

tor and a 3 prong grounding plug. The three-prong grounding

plug on the power cord should be plugged directly into a polar-

ized three-slot effectively grounded receptacle rated 110/120

Volts AC (alternating current) 15 Amps.

WARNING

This dryer is equipped with a three-prong (ground-

ing) plug for your protection against shock hazard

and should be plugged directly into a properly

grounded three-prong receptacle. Do not cut or re-

move the grounding prong from this plug.

W036

WARNING

Improper connection of the equipment-grounding

conductor can result in a risk of electric shock.

Check with a qualified electrician or service person if

you are in doubt as to whether the dryer is properly

grounded.

W038

Do not modify the plug provided with the dryer - if it will not fit

the outlet, have a proper outlet installed by a qualified electrician.

NOTE: Have a qualified electrician check the polarity of

the wall receptacle. If a voltage reading is measured

other than that listed on the dryer's nameplate, the

qualified electrician should correct the problem.

Do not operate other appliances on the same circuit when this ap-

pliance is operating.

WARNING

To reduce the risk of an electric shock or fire, DO

NOT use an extension cord or an adapter to connect

the dryer to the electrical power source.

W037

Plug cord into separately fused 15 Amp circuit.

TLW2287N_SVG

1 3

1. "L1"

2. Earth/Ground

3. Neutral Side

4. Neutral Side

5. Round Earth/Ground Prong

6. 0 V.A.C.

7. 120±12 V.A.C.

8. 120±12 V.A.C.

Figure 26

Recheck Steps

Refer to Installer Checklist on the back cover of this manual and

make sure that dryer is installed correctly.

Check Heat Source

Electric Dryers

1. Close the loading door and start the dryer in a heat setting (re-

fer to the operation instructions).

2. After the dryer has operated for three minutes, the exhaust air

or exhaust pipe should be warm.

Gas Dryers

IMPORTANT: This operation is to be conducted by

qualified personnel only.

Installation

DO NOT COPY or TRANSMIT

21 Part No. D516901EN

1 2 ... 16 17 18 19 20 21 22 23

Comments to this Manuals

No comments

Speed Queen DR5000WE Installation Manual Page 21

Comments to this Manuals

Related products and manuals for Washer dryers Speed Queen DR5000WE